Struct cc13x2_cc26x2_hal::ssi0::cr0::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn scr(&mut self) -> _SCRW

Bits 8:15 - 15:8] Serial clock rate: This is used to generate the transmit and receive bit rate of the SSI. The bit rate is (SSI's clock frequency)/((SCR+1)*CPSR.CPSDVSR). SCR is a value from 0-255.

pub fn sph(&mut self) -> _SPHW

Bit 7 - 7:7] CLKOUT phase (Motorola SPI frame format only) This bit selects the clock edge that captures data and enables it to change state. It has the most impact on the first bit transmitted by either permitting or not permitting a clock transition before the first data capture edge.

pub fn spo(&mut self) -> _SPOW

Bit 6 - 6:6] CLKOUT polarity (Motorola SPI frame format only)

pub fn frf(&mut self) -> _FRFW

Bits 4:5 - 5:4] Frame format. The supported frame formats are Motorola SPI, TI synchronous serial and National Microwire. Value 0'b11 is reserved and shall not be used.

pub fn dss(&mut self) -> _DSSW

Bits 0:3 - 3:0] Data Size Select. Values 0b0000, 0b0001, 0b0010 are reserved and shall not be used.