Struct cc13x2_cc26x2_hal::i2c0::sstat::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved3(&mut self) -> _RESERVED3W

Bits 3:31 - 31:3] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn fbr(&mut self) -> _FBRW

Bit 2 - 2:2] First byte received 0: The first byte has not been received. 1: The first byte following the slave's own address has been received. This bit is only valid when the RREQ bit is set and is automatically cleared when data has been read from the SDR register. Note: This bit is not used for slave transmit operations.

pub fn treq(&mut self) -> _TREQW

Bit 1 - 1:1] Transmit request 0: No outstanding transmit request. 1: The I2C controller has been addressed as a slave transmitter and is using clock stretching to delay the master until data has been written to the SDR register.

pub fn rreq(&mut self) -> _RREQW

Bit 0 - 0:0] Receive request 0: No outstanding receive data 1: The I2C controller has outstanding receive data from the I2C master and is using clock stretching to delay the master until data has been read from the SDR register.