Struct cc13x2_cc26x2_hal::i2c0::sstat::R

pub struct R { /* fields omitted */ }

Value read from the register

Methods

impl R

pub fn bits(&self) -> u32

Value of the register as raw bits

pub fn reserved3(&self) -> RESERVED3R

Bits 3:31 - 31:3] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn fbr(&self) -> FBRR

Bit 2 - 2:2] First byte received 0: The first byte has not been received. 1: The first byte following the slave's own address has been received. This bit is only valid when the RREQ bit is set and is automatically cleared when data has been read from the SDR register. Note: This bit is not used for slave transmit operations.

pub fn treq(&self) -> TREQR

Bit 1 - 1:1] Transmit request 0: No outstanding transmit request. 1: The I2C controller has been addressed as a slave transmitter and is using clock stretching to delay the master until data has been written to the SDR register.

pub fn rreq(&self) -> RREQR

Bit 0 - 0:0] Receive request 0: No outstanding receive data 1: The I2C controller has outstanding receive data from the I2C master and is using clock stretching to delay the master until data has been read from the SDR register.