Struct cc13x2_cc26x2_hal::crypto::irqset::R

pub struct R { /* fields omitted */ }

Value read from the register

Methods

impl R

pub fn bits(&self) -> u32

Value of the register as raw bits

pub fn reserved2(&self) -> RESERVED2R

Bits 2:31 - 31:2] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn dma_in_done(&self) -> DMA_IN_DONER

Bit 1 - 1:1] If 1 is written to this bit, the DMA data in done (irq_dma_in_done) interrupt output is set to one. Writing 0 has no effect. If the interrupt configuration register is programmed to pulse, clearing the DMA data in done (irq_dma_in_done) interrupt is not needed. If it is programmed to level, clearing the interrupt output should be done by writing the interrupt clear register (IRQCLR.DMA_IN_DONE).

pub fn result_avail(&self) -> RESULT_AVAILR

Bit 0 - 0:0] If 1 is written to this bit, the result available (irq_result_av) interrupt output is set to one. Writing 0 has no effect. If the interrupt configuration register is programmed to pulse, clearing the result available (irq_result_av) interrupt is not needed. If it is programmed to level, clearing the interrupt output should be done by writing the interrupt clear register (IRQCLR.RESULT_AVAIL).