Struct cc13x2_cc26x2_hal::crypto::dmach0len::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved16(&mut self) -> _RESERVED16W

Bits 16:31 - 31:16] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn dmalen(&mut self) -> _DMALENW

Bits 0:15 - 15:0] Channel DMA length in bytes During configuration, this register contains the DMA transfer length in bytes. During operation, it contains the last updated value of the DMA transfer length after being sent to the master interface. Note: Setting this register to a nonzero value starts the transfer if the channel is enabled. Therefore, this register must be written last when setting up a DMA channel.