[−][src]Struct cc13x2_cc26x2_hal::cpu_scs::CFSR
Configurable Fault Status This register is used to obtain information about local faults. These registers include three subsections: The first byte is Memory Manage Fault Status Register (MMFSR). The second byte is Bus Fault Status Register (BFSR). The higher half-word is Usage Fault Status Register (UFSR). The flags in these registers indicate the causes of local faults. Multiple flags can be set if more than one fault occurs. These register are read/write-clear. This means that they can be read normally, but writing a 1 to any bit clears that bit. The CFSR is byte accessible. CFSR or its subregisters can be accessed as follows: The following accesses are possible to the CFSR register: - access the complete register with a word access to 0xE000ED28. - access the MMFSR with a byte access to 0xE000ED28 - access the MMFSR and BFSR with a halfword access to 0xE000ED28 - access the BFSR with a byte access to 0xE000ED29 - access the UFSR with a halfword access to 0xE000ED2A.
Methods
impl CFSR
[src]
pub fn modify<F>(&self, f: F) where
F: FnOnce(&R, &'w mut W) -> &'w mut W,
[src]
F: FnOnce(&R, &'w mut W) -> &'w mut W,
Modifies the contents of the register
pub fn read(&self) -> R
[src]
Reads the contents of the register
pub fn write<F>(&self, f: F) where
F: FnOnce(&mut W) -> &mut W,
[src]
F: FnOnce(&mut W) -> &mut W,
Writes to the register
pub fn reset(&self)
[src]
Writes the reset value to the register
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self