[−][src]Struct cc13x2_cc26x2_hal::aux_timer2::ch3ccfg::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn reserved7(&mut self) -> _RESERVED7W
[src]
Bits 7:31 - 31:7] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn capt_src(&mut self) -> _CAPT_SRCW
[src]
Bits 1:6 - 6:1] Select capture signal source from the asynchronous AUX event bus. The selected signal enters the edge-detection circuit. False capture events can occur when: - the edge-detection circuit contains expired signal samples and the circuit is enabled without flush as described in CH3EVCFG - this register is reconfigured while CTL.MODE is different from DIS. You can avoid false capture events. When wanted channel function: - SET_ON_CAPT_DIS, see description for SET_ON_CAPT_DIS in CH3EVCFG.CCACT. - SET_ON_CAPT, see description for SET_ON_CAPT in CH3EVCFG.CCACT. - PER_PULSE_WIDTH_MEAS, see description for PER_PULSE_WIDTH_MEAS in CH3EVCFG.CCACT. If you write a non-enumerated value the behavior is identical to NO_EVENT. The written value is returned when read.
pub fn edge(&mut self) -> _EDGEW
[src]
Bit 0 - 0:0] Edge configuration. Channel captures counter value at selected edge on signal source selected by CAPT_SRC. See CH3EVCFG.CCACT.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self