Struct cc13x2_cc26x2_hal::aux_sysif::OPMODEREQ

pub struct OPMODEREQ { /* fields omitted */ }

Operational Mode Request AUX can operate in three operational modes. Each mode is associated with: - a SCE clock source or rate, given by AON_PMCTL:AUXSCECLK. This rate is termed SCE_RATE. - a system power supply state request. AUX can request powerdown (uLDO) or active (GLDO or DCDC) system power supply state. - a specific system response to an active AUX wakeup flag. The response is dependent on what operational mode is requested. uLDO power supply state offers limited current supply. AUX_SCE cannot use certain peripherals and functions such as AUX_DDI0_OSC, AUX_TDC and AUX_ANAIF ADC interface in this power supply state. Follow these rules: - It is not allowed to change a request until it has been acknowledged through OPMODEACK. - A change in mode request must happen stepwise along this sequence, the direction is irrelevant: PDA - A - LP - PDLP. Failure to follow these rules might result in unexpected behavior and must be avoided.

Methods

impl OPMODEREQ

pub fn modify<F>(&self, f: F) where
    F: FnOnce(&R, &'w mut W) -> &'w mut W, 

Modifies the contents of the register

pub fn read(&self) -> R

Reads the contents of the register

pub fn write<F>(&self, f: F) where
    F: FnOnce(&mut W) -> &mut W, 

Writes to the register

pub fn reset(&self)

Writes the reset value to the register