Struct cc13x2_cc26x2_hal::aon_pmctl::pwrctl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved3(&mut self) -> _RESERVED3W

Bits 3:31 - 31:3] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn dcdc_active(&mut self) -> _DCDC_ACTIVEW

Bit 2 - 2:2] Select to use DCDC regulator for VDDR in active mode 0: Use GLDO for regulation of VDDR in active mode. 1: Use DCDC for regulation of VDDR in active mode. DCDC_EN must also be set for DCDC to be used as regulator for VDDR in active mode

pub fn ext_reg_mode(&mut self) -> _EXT_REG_MODEW

Bit 1 - 1:1] Status of source for VDDRsupply: 0: DCDC or GLDO are generating VDDR 1: DCDC and GLDO are bypassed and an external regulator supplies VDDR

pub fn dcdc_en(&mut self) -> _DCDC_ENW

Bit 0 - 0:0] Select to use DCDC regulator during recharge of VDDR 0: Use GLDO for recharge of VDDR 1: Use DCDC for recharge of VDDR Note: This bitfield should be set to the same as DCDC_ACTIVE