[−][src]Struct cc13x2_cc26x2_hal::uart1::ctl::R
Value read from the register
Methods
impl R
[src]
pub fn bits(&self) -> u32
[src]
Value of the register as raw bits
pub fn reserved16(&self) -> RESERVED16R
[src]
Bits 16:31 - 31:16] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn ctsen(&self) -> CTSENR
[src]
Bit 15 - 15:15] CTS hardware flow control enable
pub fn rtsen(&self) -> RTSENR
[src]
Bit 14 - 14:14] RTS hardware flow control enable
pub fn reserved12(&self) -> RESERVED12R
[src]
Bits 12:13 - 13:12] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn rts(&self) -> RTSR
[src]
Bit 11 - 11:11] Request to Send This bit is the complement of the active-low UART RTS output. That is, when the bit is programmed to a 1 then RTS output on the pins is LOW.
pub fn reserved10(&self) -> RESERVED10R
[src]
Bit 10 - 10:10] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn rxe(&self) -> RXER
[src]
Bit 9 - 9:9] UART Receive Enable If the UART is disabled in the middle of reception, it completes the current character before stopping.
pub fn txe(&self) -> TXER
[src]
Bit 8 - 8:8] UART Transmit Enable If the UART is disabled in the middle of transmission, it completes the current character before stopping.
pub fn lbe(&self) -> LBER
[src]
Bit 7 - 7:7] UART Loop Back Enable: Enabling the loop-back mode connects the UARTTXD output from the UART to UARTRXD input of the UART.
pub fn reserved1(&self) -> RESERVED1R
[src]
Bits 1:6 - 6:1] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn uarten(&self) -> UARTENR
[src]
Bit 0 - 0:0] UART Enable
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self