[−][src]Struct cc13x2_cc26x2_hal::prcm::mcusramcfg::R
Value read from the register
Methods
impl R
[src]
pub fn bits(&self) -> u32
[src]
Value of the register as raw bits
pub fn reserved6(&self) -> RESERVED6R
[src]
Bits 6:31 - 31:6] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn bm_off(&self) -> BM_OFFR
[src]
Bit 5 - 5:5] Burst Mode disable 0: Burst Mode enabled. 1: Burst Mode off.
pub fn page(&self) -> PAGER
[src]
Bit 4 - 4:4] Page Mode select 0: Page Mode disabled. Memory works in standard mode 1: Page Mode enabled. Only one half of butterfly array selected. Page Mode will select either LSB half or MSB half of the word based on PGS setting. This mode can be used for additional power saving
pub fn pgs(&self) -> PGSR
[src]
Bit 3 - 3:3] 0: Select LSB half of word during Page Mode, PAGE = 1 1: Select MSB half of word during Page Mode, PAGE = 1
pub fn bm(&self) -> BMR
[src]
Bit 2 - 2:2] Burst Mode Enable 0: Burst Mode Disable. Memory works in standard mode. 1: Burst Mode Enable When in Burst Mode bitline precharge and wordline firing depends on PCH_F and PCH_L. Burst Mode results in reduction in active power.
pub fn pch_f(&self) -> PCH_FR
[src]
Bit 1 - 1:1] 0: No bitline precharge in second half of cycle 1: Bitline precharge in second half of cycle when in Burst Mode, BM = 1
pub fn pch_l(&self) -> PCH_LR
[src]
Bit 0 - 0:0] 0: No bitline precharge in first half of cycle 1: Bitline precharge in first half of cycle when in Burst Mode, BM = 1
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self