[−][src]Struct cc13x2_cc26x2_hal::aux_sysif::OPMODEREQ
Operational Mode Request AUX can operate in three operational modes. Each mode is associated with: - a SCE clock source or rate, given by AON_PMCTL:AUXSCECLK. This rate is termed SCE_RATE. - a system power supply state request. AUX can request powerdown (uLDO) or active (GLDO or DCDC) system power supply state. - a specific system response to an active AUX wakeup flag. The response is dependent on what operational mode is requested. uLDO power supply state offers limited current supply. AUX_SCE cannot use certain peripherals and functions such as AUX_DDI0_OSC, AUX_TDC and AUX_ANAIF ADC interface in this power supply state. Follow these rules: - It is not allowed to change a request until it has been acknowledged through OPMODEACK. - A change in mode request must happen stepwise along this sequence, the direction is irrelevant: PDA - A - LP - PDLP. Failure to follow these rules might result in unexpected behavior and must be avoided.
Methods
impl OPMODEREQ
[src]
pub fn modify<F>(&self, f: F) where
F: FnOnce(&R, &'w mut W) -> &'w mut W,
[src]
F: FnOnce(&R, &'w mut W) -> &'w mut W,
Modifies the contents of the register
pub fn read(&self) -> R
[src]
Reads the contents of the register
pub fn write<F>(&self, f: F) where
F: FnOnce(&mut W) -> &mut W,
[src]
F: FnOnce(&mut W) -> &mut W,
Writes to the register
pub fn reset(&self)
[src]
Writes the reset value to the register
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self