Struct cc13x2_cc26x2_hal::wdt::ctl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved3(&mut self) -> _RESERVED3W

Bits 3:31 - 31:3] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn inttype(&mut self) -> _INTTYPEW

Bit 2 - 2:2] WDT Interrupt Type 0: WDT interrupt is a standard interrupt. 1: WDT interrupt is a non-maskable interrupt.

pub fn resen(&mut self) -> _RESENW

Bit 1 - 1:1] WDT Reset Enable. Defines the function of the WDT reset source (see PRCM:WARMRESET.WDT_STAT if enabled) 0: Disabled. 1: Enable the Watchdog reset output.

pub fn inten(&mut self) -> _INTENW

Bit 0 - 0:0] WDT Interrupt Enable 0: Interrupt event disabled. 1: Interrupt event enabled. Once set, this bit can only be cleared by a hardware reset.