[−][src]Struct cc13x2_cc26x2_hal::uart1::fbrd::R
Value read from the register
Methods
impl R[src]
pub fn bits(&self) -> u32[src]
Value of the register as raw bits
pub fn divfrac(&self) -> DIVFRACR[src]
Bits 0:5 - 5:0] Fractional Baud-Rate Divisor: The baud rate divisor is calculated using the formula below: Baud rate divisor = (UART reference clock frequency) / (16 * Baud rate) Baud rate divisor must be minimum 1 and maximum 65535. That is, IBRD.DIVINT=0 does not give a valid baud rate. Similarly, if IBRD.DIVINT=0xFFFF, any non-zero values in DIVFRAC will be illegal. A valid value must be written to this field before the UART can be used for RX or TX operations.
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T> From for T[src]
impl<T, U> TryInto for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T, U> Into for T where
U: From<T>, [src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self