Struct cc13x2_cc26x2_hal::prcm::pdctl1::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved5(&mut self) -> _RESERVED5W

Bits 5:31 - 31:5] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn vims_mode(&mut self) -> _VIMS_MODEW

Bits 3:4 - 4:3] 00: VIMS power domain is only powered when CPU power domain is powered. 01: VIMS power domain is powered whenever the BUS power domain is powered. 1X: Block power up of VIMS power domain at next wake up. This mode only has effect when VIMS power domain is not powered. Used for Autonomous RF Core.

pub fn rfc_on(&mut self) -> _RFC_ONW

Bit 2 - 2:2] 0: RFC power domain powered off if also PDCTL0.RFC_ON = 0 1: RFC power domain powered on Bit shall be used by RFC in autonomous mode but there is no HW restrictions fom system CPU to access the bit.

pub fn cpu_on(&mut self) -> _CPU_ONW

Bit 1 - 1:1] 0: Causes a power down of the CPU power domain when system CPU indicates it is idle. 1: Initiates power-on of the CPU power domain. This bit is automatically set by a WIC power-on event.

pub fn reserved0(&mut self) -> _RESERVED0W

Bit 0 - 0:0] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.