Struct cc13x2_cc26x2_hal::prcm::mcusramcfg::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved6(&mut self) -> _RESERVED6W

Bits 6:31 - 31:6] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn bm_off(&mut self) -> _BM_OFFW

Bit 5 - 5:5] Burst Mode disable 0: Burst Mode enabled. 1: Burst Mode off.

pub fn page(&mut self) -> _PAGEW

Bit 4 - 4:4] Page Mode select 0: Page Mode disabled. Memory works in standard mode 1: Page Mode enabled. Only one half of butterfly array selected. Page Mode will select either LSB half or MSB half of the word based on PGS setting. This mode can be used for additional power saving

pub fn pgs(&mut self) -> _PGSW

Bit 3 - 3:3] 0: Select LSB half of word during Page Mode, PAGE = 1 1: Select MSB half of word during Page Mode, PAGE = 1

pub fn bm(&mut self) -> _BMW

Bit 2 - 2:2] Burst Mode Enable 0: Burst Mode Disable. Memory works in standard mode. 1: Burst Mode Enable When in Burst Mode bitline precharge and wordline firing depends on PCH_F and PCH_L. Burst Mode results in reduction in active power.

pub fn pch_f(&mut self) -> _PCH_FW

Bit 1 - 1:1] 0: No bitline precharge in second half of cycle 1: Bitline precharge in second half of cycle when in Burst Mode, BM = 1

pub fn pch_l(&mut self) -> _PCH_LW

Bit 0 - 0:0] 0: No bitline precharge in first half of cycle 1: Bitline precharge in first half of cycle when in Burst Mode, BM = 1