Struct cc13x2_cc26x2_hal::aux_tdc::stat::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved8(&mut self) -> _RESERVED8W

Bits 8:31 - 31:8] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn sat(&mut self) -> _SATW

Bit 7 - 7:7] TDC measurement saturation flag. 0: Conversion has not saturated. 1: Conversion stopped due to saturation. This field is cleared when a new measurement is started or when CLR_RESULT is written to CTL.CMD.

pub fn done(&mut self) -> _DONEW

Bit 6 - 6:6] TDC measurement complete flag. 0: TDC measurement has not yet completed. 1: TDC measurement has completed. This field clears when a new TDC measurement starts or when you write CLR_RESULT to CTL.CMD.

pub fn state(&mut self) -> _STATEW

Bits 0:5 - 5:0] TDC state machine status.