Struct cc13x2_cc26x2_hal::aux_anaif::dacctl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn reserved6(&mut self) -> _RESERVED6W

Bits 6:31 - 31:6] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn dac_en(&mut self) -> _DAC_ENW

Bit 5 - 5:5] DAC module enable. 0: Disable DAC. 1: Enable DAC. The Sensor Controller must not use the DAC when AUX_SYSIF:OPMODEREQ.REQ equals PDA. The System CPU must not use the DAC when AUX_SYSIF:OPMODEREQ.REQ equals PDA in Standby TI-RTOS power mode. The System CPU must set AUX_SYSIF:PEROPRATE.ANAIF_DAC_OP_RATE to BUS_RATE to use the DAC in Active and Idle TI-RTOS power modes.

pub fn dac_buffer_en(&mut self) -> _DAC_BUFFER_ENW

Bit 4 - 4:4] DAC buffer enable. DAC buffer reduces the time required to produce the programmed voltage at the expense of increased current consumption. 0: Disable DAC buffer. 1: Enable DAC buffer. Enable buffer when DAC_VOUT_SEL equals COMPA_IN. Do not enable the buffer when AUX_SYSIF:OPMODEREQ.REQ equals PDA or PDLP.

pub fn dac_precharge_en(&mut self) -> _DAC_PRECHARGE_ENW

Bit 3 - 3:3] DAC precharge enable. Only enable precharge when ADI_4_AUX:MUX2.DAC_VREF_SEL equals DCOUPL and VDDS is higher than 2.65 V. DAC output voltage range: 0: 0 V to 1.28 V. 1: 1.28 V to 2.56 V. Otherwise, see ADI_4_AUX:MUX2.DAC_VREF_SEL for DAC output voltage range. Enable precharge 1 us before you enable the DAC and the buffer.

pub fn dac_vout_sel(&mut self) -> _DAC_VOUT_SELW

Bits 0:2 - 2:0] DAC output connection. An analog node must only have one driver. Other drivers for the following analog nodes are configured in [ANATOP_MMAP::ADI_4_AUX:*].