@brief Calculate CRC32 checksum on byte array
@brief Get continuous sweep mode
@brief Set continuous sweep mode
@brief Create a configuration
@brief Destroy a configuration freeing any resources allocated
@brief Get the double buffering configuration
@brief Enable or disable double buffering
@brief Get the enable loopback configuration
@brief Enable or disable loopback
@brief Get transmitter enable configuration
@brief Enable or disable the transmitter
@brief Get the frame rate
@brief Set the frame rate
@brief Get the hardware accelerated average samples (HWAAS)
@brief Set the hardware accelerated average samples (HWAAS)
@brief Get inter frame idle state
@brief Set inter frame idle state
@brief Get inter sweep idle state
@brief Set inter sweep idle state
@brief Print a configuration to the log
@brief Get the number of data points to measure
@brief Set the number of data points to measure
@brief Get the number of subsweeps to use
@brief Set the number of subsweeps to use
@brief Get the phase enhancement configuration
@brief Enable or disable phase enhancement
@brief Get Pulse Repetition Frequency
@brief Set Pulse Repetition Frequency
@brief Get the currently used profile
@brief Set a profile
@brief Get receiver gain setting
@brief Set receiver gain setting
@brief Get the starting point of the sweep
@brief Set the starting point of the sweep
@brief Get the step length in a sweep
@brief Set the step length in a sweep
@brief Get the enable loopback configuration
@brief Set the loopback enabled configuration
@brief Get transmitter enable mode
@brief Enable or disable the transmitter
@brief Get the hardware accelerated average samples (HWAAS)
@brief Set the hardware accelerated average samples (HWAAS)
@brief Get the number of data points to measure
@brief Set the number of data points to measure
@brief Get the phase enhancement enabled configuration
@brief Set the phase enhancement enabled configuration
@brief Get Pulse Repetition Frequency
@brief Set Pulse Repetition Frequency
@brief Get the currently used profile
@brief Set a profile
@brief Get receiver gain setting
@brief Set receiver gain setting
@brief Get the starting point of the sweep
@brief Set the starting point of the sweep
@brief Get the step length in a sweep
@brief Set the step length in a sweep
@brief Get the sweep rate
@brief Set the sweep rate
@brief Get the number of sweeps per frame
@brief Set sweeps per frame
@brief Create a processing instance with the provided configuration
@brief Destroy a processing instance identified with the provided processing handle
@brief Process the data according to the configuration used in create
@brief Convert a distance or step length in meter to points
@brief Convert a distance or step length in points to meter
@brief Create a sensor assembly test instance
@brief Destroy a sensor assembly test instance freeing any resources allocated.
@brief Disable a test in assembly test
@brief Disable all assembly tests
@brief Enable a test in assembly test
@brief Enable all assembly tests
@brief Enable disagnostic logs for the assembly test,
@brief Execute the assembly test
@brief A function to get the results from the sensor assembly test
@brief Get the buffer size needed for the specified config
@brief Register an integration
@brief Set the log level that determines when the integration HAL logger function is called
@brief Calibrate a sensor
@brief Check if a sensor is connected and responsive
@brief Create a sensor instance
@brief Destroy a sensor instance freeing any resources allocated.
@brief Gets calibration information from a calibration result
@brief Restore sensor after exiting hibernation
@brief Prepare sensor for entering hibernation
@brief Start a radar measurement with previously prepared configuration
@brief Prepare a sensor to do a measurement
@brief Read out radar data
@brief Check the status of the sensor
@brief Validate calibration result
@brief Get the version of the Acconeer software
@brief Get the version of the Acconeer software as a hex number