Module trellis_m4::thumbv7em::nvm
source ·
[−]Expand description
Non-volatile Memory Controller
This module allows users to interact with non-volatile memory controller.
NVMCTRL is an intermediary between memory buses and physical non-volatile
memory. It provides means of managing a flash memory content, its properties
(cache, wait states, bootloader blocks protection), power management and
address remapping if necessary (in case bank mechanism is used). It also
provides an indirection mechanism to achieve non-volatile RAM-like memory
within last sectors of a physical flash (More in smart_eeprom module).
NVM supports splitting flash into two sections (opt-in feature) called
banks. Bank considered active is mapped to virtual address 0x0, meaning
it contains currently executed application. Through NVM command & control
interface, banks can be swapped and MCU reset, so the firmware from the
other bank will run after restart.
Module features:
- Erase & write over non-volatile memory in a device.
- Swap banks
Modules
SmartEEPROM
Structs
POD-style struct representing NVM calibration area
Non-volatile memory controller
POD-style struct representing NVM calibration area for temperature calibration
POD-style struct representing NVM user page
Enums
Flash banks identified by which one we boot from.
Data erased per command
Driver errors
Power Reduction Mode during Sleep
Errors generated by the NVM peripheral
Physical flash banks
Constants
Functions
Retrieve a bank size using HW registers
Retrieve a total NVM size using HW registers
Type Definitions
NVM result type