Enum stm32wb_hci::host::Error

pub enum Error<VS> {
    BadDisconnectionReason(Status<VS>),
    BadRandomAddress(BdAddr),
    BadChannelMap(Channels),
    AdvertisingDataTooLong(usize),
    BadConnectionLengthRange(Duration, Duration),
    NoValidChannel,
    InvalidTestChannel(u8),
    InvalidTestPayloadLength(usize),
}

Errors that may occur when sending commands to the controller. Must be specialized on the types of communication errors.

Variants

BadDisconnectionReason(Status<VS>)

For the disconnect command: The provided reason is not a valid disconnection reason. Includes the reported reason.

BadRandomAddress(BdAddr)

For the le_set_random_address command: The provided address does not meet the rules for random addresses in the Bluetooth Spec, Vol 6, Part B, Section 1.3. Includes the invalid address.

BadChannelMap(Channels)

For the le_set_advertising_parameters command: The channel map did not include any enabled channels. Includes the provided channel map.

AdvertisingDataTooLong(usize)

For the le_set_advertising_data or le_set_scan_response_data commands: The provided data is too long to fit in the command. The maximum allowed length is 31. The actual length is returned.

BadConnectionLengthRange(Duration, Duration)

For the le_create_connection command: the connection length range is inverted (i.e, the minimum is greater than the maximum). Returns the range, min first.

NoValidChannel

For the le_set_host_channel_classification command: all channels were marked ‘bad’.

InvalidTestChannel(u8)

For the le_receiver_test and le_transmitter_test commands: the channel was out of range. The maximum allowed channel is 39. Includes the invalid value.

InvalidTestPayloadLength(usize)

For the le_transmitter_test command: The payload length is invalid. The maximum value is 37. Includes the invalid value.

Trait Implementations

impl<VS: Clone> Clone for Error<VS>

fn clone(&self) -> Error<VS>

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl<VS: Debug> Debug for Error<VS>

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl<VS: PartialEq> PartialEq<Error<VS>> for Error<VS>

fn eq(&self, other: &Error<VS>) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl<VS: Copy> Copy for Error<VS>

impl<VS> StructuralPartialEq for Error<VS>