Module stm32h7::stm32h743v::crs::cr

source · [−]
Expand description

CRS control register

Structs

CR_SPEC

CRS control register

R

Register CR reader

W

Register CR writer

Type Definitions

AUTOTRIMEN_R

Field AUTOTRIMEN reader - Automatic trimming enable This bit enables the automatic hardware adjustment of TRIM bits according to the measured frequency error between two SYNC events. If this bit is set, the TRIM bits are read-only. The TRIM value can be adjusted by hardware by one or two steps at a time, depending on the measured frequency error value. Refer to Section7.3.4: Frequency error evaluation and automatic trimming for more details.

AUTOTRIMEN_W

Field AUTOTRIMEN writer - Automatic trimming enable This bit enables the automatic hardware adjustment of TRIM bits according to the measured frequency error between two SYNC events. If this bit is set, the TRIM bits are read-only. The TRIM value can be adjusted by hardware by one or two steps at a time, depending on the measured frequency error value. Refer to Section7.3.4: Frequency error evaluation and automatic trimming for more details.

CEN_R

Field CEN reader - Frequency error counter enable This bit enables the oscillator clock for the frequency error counter. When this bit is set, the CRS_CFGR register is write-protected and cannot be modified.

CEN_W

Field CEN writer - Frequency error counter enable This bit enables the oscillator clock for the frequency error counter. When this bit is set, the CRS_CFGR register is write-protected and cannot be modified.

ERRIE_R

Field ERRIE reader - Synchronization or trimming error interrupt enable

ERRIE_W

Field ERRIE writer - Synchronization or trimming error interrupt enable

ESYNCIE_R

Field ESYNCIE reader - Expected SYNC interrupt enable

ESYNCIE_W

Field ESYNCIE writer - Expected SYNC interrupt enable

SWSYNC_R

Field SWSYNC reader - Generate software SYNC event This bit is set by software in order to generate a software SYNC event. It is automatically cleared by hardware.

SYNCOKIE_R

Field SYNCOKIE reader - SYNC event OK interrupt enable

SYNCOKIE_W

Field SYNCOKIE writer - SYNC event OK interrupt enable

SYNCWARNIE_R

Field SYNCWARNIE reader - SYNC warning interrupt enable

SYNCWARNIE_W

Field SYNCWARNIE writer - SYNC warning interrupt enable

TRIM_R

Field TRIM reader - HSI48 oscillator smooth trimming These bits provide a user-programmable trimming value to the HSI48 oscillator. They can be programmed to adjust to variations in voltage and temperature that influence the frequency of the HSI48. The default value is 32, which corresponds to the middle of the trimming interval. The trimming step is around 67 kHz between two consecutive TRIM steps. A higher TRIM value corresponds to a higher output frequency. When the AUTOTRIMEN bit is set, this field is controlled by hardware and is read-only.

TRIM_W

Field TRIM writer - HSI48 oscillator smooth trimming These bits provide a user-programmable trimming value to the HSI48 oscillator. They can be programmed to adjust to variations in voltage and temperature that influence the frequency of the HSI48. The default value is 32, which corresponds to the middle of the trimming interval. The trimming step is around 67 kHz between two consecutive TRIM steps. A higher TRIM value corresponds to a higher output frequency. When the AUTOTRIMEN bit is set, this field is controlled by hardware and is read-only.