1
  2
  3
  4
  5
  6
  7
  8
  9
 10
 11
 12
 13
 14
 15
 16
 17
 18
 19
 20
 21
 22
 23
 24
 25
 26
 27
 28
 29
 30
 31
 32
 33
 34
 35
 36
 37
 38
 39
 40
 41
 42
 43
 44
 45
 46
 47
 48
 49
 50
 51
 52
 53
 54
 55
 56
 57
 58
 59
 60
 61
 62
 63
 64
 65
 66
 67
 68
 69
 70
 71
 72
 73
 74
 75
 76
 77
 78
 79
 80
 81
 82
 83
 84
 85
 86
 87
 88
 89
 90
 91
 92
 93
 94
 95
 96
 97
 98
 99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159

use crate::{
    BitFlags, Error, ErrorWithPin, OperationState, Register, SeekDirection, SeekFmImpulseThreshold,
    SeekMode, SeekSnrThreshold, Si4703,
};
use embedded_hal::{blocking::i2c, digital::v2::InputPin};

impl<I2C, E, IC> Si4703<I2C, IC>
where
    I2C: i2c::Write<Error = E> + i2c::Read<Error = E>,
{
    fn get_powercfg_for_seek_config(
        powercfg: u16,
        mode: SeekMode,
        direction: SeekDirection,
    ) -> u16 {
        let powercfg = match mode {
            SeekMode::Wrap => powercfg | BitFlags::SKMODE,
            SeekMode::NoWrap => powercfg & !BitFlags::SKMODE,
        };
        match direction {
            SeekDirection::Up => powercfg | BitFlags::SEEKUP,
            SeekDirection::Down => powercfg & !BitFlags::SEEKUP,
        }
    }

    /// Configure seek RSSI, SNR and FM impulse detection thresholds
    pub fn configure_seek(
        &mut self,
        rssi_threshold: u8,
        snr_threshold: SeekSnrThreshold,
        fm_impulse_threshold: SeekFmImpulseThreshold,
    ) -> Result<(), Error<E>> {
        let snr_mask = match snr_threshold {
            SeekSnrThreshold::Disabled => 0,
            SeekSnrThreshold::Enabled(v) if v > 7 || v == 0 => return Err(Error::InvalidInputData),
            SeekSnrThreshold::Enabled(v) => v << 4,
        };
        let cnt_mask = match fm_impulse_threshold {
            SeekFmImpulseThreshold::Disabled => 0,
            SeekFmImpulseThreshold::Enabled(v) if v > 15 || v == 0 => {
                return Err(Error::InvalidInputData)
            }
            SeekFmImpulseThreshold::Enabled(v) => v,
        };
        let mut regs = self.read_registers()?;
        regs[Register::SYSCONFIG2] &= 0xFF00;
        regs[Register::SYSCONFIG2] |= u16::from(rssi_threshold) << 8;
        regs[Register::SYSCONFIG3] &= 0xFF00;
        regs[Register::SYSCONFIG3] |= u16::from(snr_mask | cnt_mask);
        self.write_registers(&regs[..=Register::SYSCONFIG3])
    }

    /// Seek
    ///
    /// It is not recommended to call this again this while the seeking
    /// is not finished. It should be waited on the STC interrupt pin.
    pub fn seek(&mut self, mode: SeekMode, direction: SeekDirection) -> nb::Result<(), Error<E>> {
        let set_initial_value = |regs: &mut [u16; 16]| {
            let powercfg = regs[Register::POWERCFG] | BitFlags::SEEK;
            regs[Register::POWERCFG] =
                Self::get_powercfg_for_seek_config(powercfg, mode, direction);
            Ok(Register::POWERCFG)
        };
        let mut state = self.seeking_state;
        let result = self.tune_seek(
            Register::POWERCFG,
            BitFlags::SEEK,
            &mut state,
            &set_initial_value,
        );
        self.seeking_state = state;
        result
    }

    /// Seek using GPIO2 as STC interrupt pin (recommended)
    ///
    /// This will configure GPIO2 as STC interrupt pin and enable
    /// STC interrupts if appropriate.
    pub fn seek_with_stc_int_pin<PinE, P: InputPin<Error = PinE>>(
        &mut self,
        mode: SeekMode,
        direction: SeekDirection,
        stc_int_pin: &P,
    ) -> nb::Result<(), ErrorWithPin<E, PinE>> {
        if self.seeking_state == OperationState::Busy
            && stc_int_pin
                .is_high()
                .map_err(ErrorWithPin::Pin)
                .map_err(nb::Error::Other)?
        {
            Err(nb::Error::WouldBlock)
        } else {
            let set_initial_value = |regs: &mut [u16; 16]| {
                let powercfg = regs[Register::POWERCFG] | BitFlags::SEEK;
                regs[Register::POWERCFG] =
                    Self::get_powercfg_for_seek_config(powercfg, mode, direction);
                let previous_sysconfig1 = regs[Register::SYSCONFIG1];
                regs[Register::SYSCONFIG1] &= 0xFFF3;
                regs[Register::SYSCONFIG1] |= 1 << 2;
                regs[Register::SYSCONFIG1] |= BitFlags::STCIEN;
                if previous_sysconfig1 != regs[Register::SYSCONFIG1] {
                    Ok(Register::SYSCONFIG1)
                } else {
                    Ok(Register::POWERCFG)
                }
            };
            let mut state = self.seeking_state;
            let result = self.tune_seek(
                Register::POWERCFG,
                BitFlags::SEEK,
                &mut state,
                &set_initial_value,
            );
            self.seeking_state = state;
            result.map_err(|e| match e {
                nb::Error::Other(e) => nb::Error::Other(e.into()),
                nb::Error::WouldBlock => nb::Error::WouldBlock,
            })
        }
    }

    pub(crate) fn tune_seek(
        &mut self,
        register: usize,
        bitflag: u16,
        state: &mut OperationState,
        set_start_value: &dyn Fn(&mut [u16; 16]) -> Result<usize, Error<E>>,
    ) -> nb::Result<(), Error<E>> {
        let mut regs = self.read_registers()?;
        let flag = (regs[register] & bitflag) != 0;
        let stc = (regs[Register::STATUSRSSI] & BitFlags::STC) != 0;
        let failed = (regs[Register::STATUSRSSI] & BitFlags::SF_BL) != 0;
        let afcrl = (regs[Register::STATUSRSSI] & BitFlags::AFCRL) != 0;

        match (*state, flag, stc) {
            (OperationState::Idle, false, false) => {
                let register = set_start_value(&mut regs)?;
                self.write_registers(&regs[..=register])?;
                *state = OperationState::Busy;
                Err(nb::Error::WouldBlock)
            }
            (OperationState::Busy, true, true) => {
                regs[register] &= !bitflag;
                self.write_registers(&regs[..=register])?;
                *state = OperationState::WaitingForStcToClear(!failed && !afcrl);
                Err(nb::Error::WouldBlock)
            }
            (OperationState::WaitingForStcToClear(success), false, false) => {
                *state = OperationState::Idle;
                if success {
                    Ok(())
                } else {
                    Err(nb::Error::Other(Error::SeekFailed))
                }
            }
            (_, _, _) => Err(nb::Error::WouldBlock),
        }
    }
}