Module redpitaya::acquire
[−]
[src]
Enums
Decimation | |
SamplingRate | |
TrigSrc | |
TrigState |
Functions
get_averaging |
Returns information if averaging of data between samples is enabled or disabled. |
get_buffer_size | |
get_data_pos_raw |
Returns the ADC buffer in raw units from start to end position. |
get_data_pos_v |
Returns the ADC buffer in Volt units from start to end position. |
get_data_raw |
Returns the ADC buffer in raw units from specified position. |
get_data_raw_v2 |
Returns the ADC buffer in raw units from specified position. |
get_data_v |
Returns the ADC buffer in Volt units from specified position. |
get_data_v2 |
Returns the ADC buffer in Volt units from specified position. |
get_decimation |
Gets the decimation used at acquiring signal. |
get_decimation_factor |
Gets the decimation factor used at acquiring signal in a numerical form. |
get_gain |
Returns the currently set acquire gain state in the library. |
get_gain_v |
Returns the currently set acquire gain in the library. |
get_latest_data_raw |
Returns the latest ADC buffer samples in raw units. |
get_latest_data_v |
Returns the latest ADC buffer samples in Volt units. |
get_normalized_data_pos |
Normalizes the ADC buffer position. |
get_oldest_data_raw |
Returns the ADC buffer in raw units from the oldest sample to the newest one. |
get_oldest_data_v |
Returns the ADC buffer in Volt units from the oldest sample to the newest one. |
get_pre_trigger_counter |
Returns the number of valid data ponts before trigger. |
get_sampling_rate |
Gets the sampling rate for acquiring signal. |
get_sampling_rate_hz |
Gets the sampling rate for acquiring signal in a numerical form in Hz. |
get_trigger_delay |
Returns current number of decimated data after trigger written into memory. |
get_trigger_delay_ns |
Returns the current amount of decimated data in nanoseconds after trigger written into memory. |
get_trigger_hyst |
Gets currently set trigger threshold hysteresis value in volts. |
get_trigger_level |
Gets currently set trigger threshold value in volts. |
get_trigger_src |
Gets the trigger source used at acquiring signal. |
get_trigger_state |
Returns the trigger state. |
get_write_pointer |
Returns current position of ADC write pointer. |
get_write_pointer_at_trig |
Returns position of ADC write pointer at time when trigger arrived. |
reset |
Resets the acquire writing state machine. |
set_arm_keep |
Enables continous acquirement even after trigger has happened. |
set_averaging |
Enables or disables averaging of data between samples. |
set_decimation |
Sets the decimation used at acquiring signal. |
set_gain |
Sets the acquire gain state. |
set_sampling_rate |
Sets the sampling rate for acquiring signal. |
set_trigger_delay |
Sets the number of decimated data after trigger written into memory. |
set_trigger_delay_ns |
Sets the amount of decimated data in nanoseconds after trigger written into memory. |
set_trigger_hyst |
Sets the trigger threshold hysteresis value in volts. |
set_trigger_level |
Sets the trigger threshold value in volts. |
set_trigger_src |
Sets the trigger source used at acquiring signal. |
start |
Starts the acquire. |
stop |
Stops the acquire. |