Module mcp9808::reg_conf
[−]
[src]
Enums
| AlertControl |
Alert Output Control bit This bit can not be altered when either of the Lock bits are set (bit 6 and bit 7). This bit can be programmed in Shutdown mode, but the Alert output will not assert or deassert. |
| AlertMode |
Alert Output Mode bit This bit cannot be altered when either of the Lock bits are set (bit 6 and bit 7). This bit can be programmed in Shutdown mode, but the Alert output will not assert or deassert. |
| AlertPolarity |
Alert Output Polarity bit This bit cannot be altered when either of the Lock bits are set (bit 6 and bit 7). This bit can be programmed in Shutdown mode, but the Alert output will not assert or deassert. |
| AlertSelect |
Alert Output Select bit When the Alarm Window Lock bit is set, this bit cannot be altered until unlocked (bit 6). This bit can be programmed in Shutdown mode, but the Alert output will not assert or deassert. |
| AlertStatus |
Alert Output Status bit This bit can not be set to ‘1’ or cleared to ‘0’ in Shutdown mode. However, if the Alert output is configured as Interrupt mode, and if the host controller clears to ‘0’, the interrupt, using bit 5 while the device is in Shutdown mode, then this bit will also be cleared ‘0’. |
| CriticalLock |
When enabled, this bit remains set to ‘1’ or locked until cleared by an internal Reset. |
| Hysteresis |
tUPPER and tLOWER Limit Hysteresis bits This bit can not be altered when either of the Lock bits are set (bit 6 and bit 7). This bit can be programmed in Shutdown mode. |
| InterruptClear |
Interrupt Clear bit This bit can not be set to ‘1’ in Shutdown mode, but it can be cleared after the device enters Shutdown mode. |
| ShutdownMode |
In shutdown, all power-consuming activities are disabled, though all registers can be written to or read. This bit cannot be set to ‘1’ when either of the Lock bits is set (bit 6 and bit 7). However, it can be cleared to ‘0’ for continuous conversion while locked. |
| WindowLock |
tUPPER and tLOWER Window Lock bit When enabled, this bit remains set to ‘1’ or locked until cleared by a Power-on Reset. |
Traits
| Configuration |
Functions
| new |