Expand description
Rust driver for MCP4728 4-channel 12-bit I2C DAC
This is a platform agnostic rust driver for the MCP4728 DAC using the embedded-hal traits.
This driver allows you to:
- Write to a single channel and save to EEPROM
- Write to multiple channels and save to EEPROM
- Write to all channels, skipping some configuration bits and not saving to EEPROM (“fast write”)
- Write voltage reference mode to all channels
- Write gain mode to all channels
- Write power down mode to all channels
- Read EEPROM and output registers for all channels
- Issue I2C General Call commands: reset, wake up, and software update
There is one feature that this driver does not support - reading and writing the I2C address of the device. Three bits of the driver can be set (from 0x60 to 0x67) but this is done by toggling another pin in precise timing with the I2C message, which is not possible to do using the embedded-hal traits.
Device
The MCP4728 is a 4-channel, 12-bit digital-to-analog converter with nonvolatile memory (EEPROM) for its output settings. The device will load its previous setting from EEPROM on startup without receiving any commands. Each channel has separate voltage reference, gain, and power down settings. Channels can be written individually or together.
Datasheet
Usage
use linux_embedded_hal::I2cdev;
use mcp4728::{MCP4728};
let i2c = I2cdev::new("/dev/i2c-1").unwrap();
let mut dac = MCP4728::new(i2c, 0x60);
dac.fast_write(483, 279, 297, 590).unwrap();
Updating the analog outputs
Most commands write to the output register but do not necessarily update the analog output. There are several ways to do so:
- If
OutputEnableMode
isUpdate
, the output will be updated after the last byte is received for each channel (not all commands can set this bit) - If the LDAC pin is set low, the output will be updated after the last byte is received for each channel.
- If the LDAC pin transitions from high to low at any time, all channels will be updated.
- If a General Call Software Update command is received, all channels will be updated.