Crate trinket_m0

Re-exports

pub use cortex_m_rt::entry;

pub use hal::target_device as pac;

Modules

calibration	NVM Software Calibration Area Mapping
clock	Configuring the system clock sources. You will typically need to create an instance of GenericClockController before you can set up most of the peripherals on the atsamd21 device. The other types in this module are used to enforce at compile time that the peripherals have been correctly configured.
delay	Delays
gpio	Working with GPIO pins. The pins are associated with the PORT hardware. This module defines a split method on the PORT type that is used to safely reference the individual pin configuration. The IO pins can be switched into alternate function modes, which routes the pins to different peripherals depending on the mode for the pin. The pin configuration is reflected through the use of type states to make the interface (ideally, or at least practically) impossible to misuse.
pad
prelude	Import the prelude to gain convenient access to helper traits
pwm
sercom	Working with the SERCOM peripherals.
time	Time units
timer	Working with timer counter hardware

Structs

Pins	Maps the pins to their arduino names and the numbers printed on the board.

Functions

i2c_master	Convenience for setting up the D0 and D2 pins to operate as I²C SDA/SDL (respectively) running at the specified baud.
uart	Convenience for setting up the D3 and D4 pins to operate as UART RX/TX (respectively) running at the specified baud.