[−][src]Crate trellis_m4
Re-exports
pub use adxl343; |
pub use keypad; |
pub use hal::target_device as pac; |
pub use pins::Pins; |
Modules
adc | |
calibration | NVM Software Calibration Area Mapping |
clock | Configuring the system clock sources.
You will typically need to create an instance of |
delay | Delays |
eic | |
gpio | GPIO |
pad | |
pins | NeoTrellis M4 Express pins |
prelude | Import the prelude to gain convenient access to helper traits |
pwm | |
qspi | |
rtc | Real-time clock/counter |
sercom | Configure the SERCOM peripherals |
sleeping_delay | Delays with WFI sleep while we wait using a timer |
spi_common | |
time | Time units |
timer | Working with timer counter hardware |
timer_params | helper struct to calculate divider & cycles settings for timers. |
timer_traits | |
trng | |
watchdog |
Structs
Keypad | NeoTrellis M4 Express 8x4 keypad |
Enums
ResetCause | ResetCause represents the reason the MCU was reset. |
Constants
NEOPIXEL_COUNT | Number of Neopixels on the device |
Functions
i2c_master | Convenience for setting up the labelled SDA, SCL pins to operate as an I2C master running at the specified frequency. |
reset_cause | Returns the cause of the last reset. |
serial_number | Returns the serial number of the chip as an array of bytes. The serial number is only guaranteed to be unique if all 16 bytes are used. |
split_serial_number | Returns the serial number of the chip as 4 32-bit integers. The serial number is only guaranteed to be unique if all 128 bits are used. |
uart | Convenience for setting up the labelled SDA, SCL pins in the STEMMA JST connector to operate as a UART device at the specified baud rate. |
Attribute Macros
entry | Attribute to declare the entry point of the program |