[−][src]Crate pygamer

Re-exports

pub use cortex_m_rt::entry;

pub use crate::pins::Pins;

pub use hal::target_device as pac;

clock	Configuring the system clock sources. You will typically need to create an instance of `GenericClockController` before you can set up most of the peripherals on the atsamd51 device. The other types in this module are used to enforce at compile time that the peripherals have been correctly configured.
delay	Delays
gpio	Working with GPIO pins. The pins are associated with the PORT hardware. This module defines a `split` method on the `PORT` type that is used to safely reference the individual pin configuration. The IO pins can be switched into alternate function modes, which routes the pins to different peripherals depending on the mode for the pin. The pin configuration is reflected through the use of type states to make the interface (ideally, or at least practically) impossible to misuse.
pad
pins	PyGamer pins
prelude	Import the prelude to gain convenient access to helper traits
pwm
sercom	Working with the SERCOM peripherals.
time	Time units
timer	Working with timer counter hardware
trng

display	Convenience for accessing the on-board TFT LCD.
i2c_master	Convenience for setting up the labelled SDA, SCL pins to operate as an I2C master running at the specified frequency.
spi_master	This powers up SERCOM1 and configures it for use as an SPI Master in SPI Mode 0. This function does not accept a CS pin; configuring a pin for CS is the responsibility of the caller, because it could be any OutputPin, or even a pulled up line on the slave.
uart	Convenience for setting up UART on the FeatherWing socket’s RX/TX pins