[−][src]Crate itsybitsy_m4

Re-exports

pub use hal::target_device as pac;

pub use pins::Pins;

adc
calibration	NVM Software Calibration Area Mapping
clock	Configuring the system clock sources. You will typically need to create an instance of `GenericClockController` before you can set up most of the peripherals on the atsamd51 device. The other types in this module are used to enforce at compile time that the peripherals have been correctly configured.
delay	Delays
gpio	Working with GPIO pins. The pins are associated with the PORT hardware. This module defines a `split` method on the `PORT` type that is used to safely reference the individual pin configuration. The IO pins can be switched into alternate function modes, which routes the pins to different peripherals depending on the mode for the pin. The pin configuration is reflected through the use of type states to make the interface (ideally, or at least practically) impossible to misuse.
pad
pins	ItsyBitsy M4 Express pins
prelude	Import the prelude to gain convenient access to helper traits
pwm
sercom	Working with the SERCOM peripherals.
time	Time units
timer	Working with timer counter hardware
trng

dotstar_bitbang	Convenience for setting up the dotstar LED using bitbang'ed SPI.
i2c_master	Convenience for setting up the labelled SDA, SCL pins to operate as an I2C master running at the specified frequency.
spi_master	Convenience for setting up the labelled SPI peripheral. This powers up SERCOM1 and configures it for use as an SPI Master in SPI Mode 0.
uart	Convenience for setting up the labelled TX, RX pins to operate as a UART running at the specified frequency.

Attribute to declare the entry point of the program