docs.rs failed to build esp-idf-hal-0.29.5
Please check the build logs for more information.
See Builds for ideas on how to fix a failed build, or Metadata for how to configure docs.rs builds.
If you believe this is docs.rs' fault, open an issue.
Please check the build logs for more information.
See Builds for ideas on how to fix a failed build, or Metadata for how to configure docs.rs builds.
If you believe this is docs.rs' fault, open an issue.
Visit the last successful build:
esp-idf-hal-0.1.2
An embedded-hal implementation for Rust on ESP32 and ESP-IDF
- This crate is intended for usage in ESP32 embedded projects that utilize and link with the ESP-IDF SDK.
- For embedded projects that don't need Rust STD support, WiFi or BLE (and thus don't link with the ESP-IDF SDK), please check esp32-hal.
For more information, check out:
- The Rust ESP32 STD compiler fork
- The "Hello, World" demo
- The esp-idf-svc project
- The embedded-hal project
- The esp32-hal project
Hardware Notes
Each chip has a number of GPIO pins which are generally used by the SPI0 and SPI1 peripherals in order to connect external PSRAM and/or SPI Flash memory. The datasheets explicitly state that these are not recommended for use, however this crate includes them anyways for completeness.
Please refer to the table below to determine the pins which are not recommended for use for your chip.
| Chip | GPIOs |
|---|---|
| ESP32 | 6 - 11, 16 - 17 |
| ESP32-C3 | 12 - 17 |
| ESP32-S2 | 26 - 32 |
| ESP32-S3 | 26 - 32, 33 - 37* |
* When using Octal Flash and/or Octal PSRAM