Introduction

This is a port of the adafruit python module (https://github.com/adafruit/Adafruit_CircuitPython_GPS) that reads and parses the NMEA data sentences from their Ultimate GPS and Adafruit Mini GPS PA1010D. Most of this readme is also pulled directly from the adafruit library.

The GPS module provides a serial byte signal providing longitude, latitude and metadata.

This module has only been tested using an Adafruit Mini GPS PA1010D on a raspberry pi zero.

Note

3.0 update introduced breaking changes to Gps struct and open port in an attempt to increase gps Hz.

Dependencies

Serialport: https://docs.rs/serialport/3.2.0/serialport/. Serialport is used for reading the byte information provided by the GPS as well as sending it commands.

Serial dependencies are:

For GNU Linux pkg-config and libudev headers are required:

Ubuntu: sudo apt install pkg-config libudev-dev
Fedora: sudo dnf install pkgconf-pkg-config systemd-devel
Other: Some Linux distros are providing pkgconf.org's pkgconf package instead of freedesktop.org's pkg-config.

Usage

See example/simple.rs for examples on basic usage.

For more advanced usage, read the specs.md for the commands that can be read and commands that can be sent.

Notes the baud rate and gps output frequency

For the 3.0 update, I've tried to get the gps to increase it's update frequency to 10Hz.

To increase the frequency, the baud rate of the gps AND the port need to be changed to allow for more data to be outputted. To do this, at the beginning of the file, before opening the port, the baud rate must be set (unless the default 9600 is what you want). See increase_frequency.rs for an example.

set_baud_rate takes a while and is error prone, so ideally set the baud rate and frequency and use a battery/keep power so that the settings are retained. If power is lost (and there is no battery), settings are reset to 9600 baud rate and 1000 mili frequency.

1000 baud = 1000 symbols per second. baud_rate calculations. Gps max sentence length is 255 (or close enough). 9600 -> allows a minimum of 37.64 sentences per second or 3.7 sentences per second at 10Hz. GGA -> 1/iter VTG -> 1/iter GSA -> 1/iter RMC -> 1/iter GLL -> 1/iter GSV -> up to 4/iter

Notes on the code and contributing

This crate library has mostly been made as a personal challenge and to fill a narrow gap so all contributions are welcome. That said, this code is likely to need improvement, all of which is welcome.