[−][src]Module cc2650::aux_tdcif
AUX Time To Digital Converter
Modules
ctl | Control |
precnt | Prescaler Counter |
prectl | Prescaler Control The prescaler can be used to count events that are faster than the AUX clock frequency. It can be used to: - count pulses on a specified event from the asynchronous event bus. - prescale a specified event from the asynchronous event bus. To use the prescaler output as an event source in TDC measurements you must set both TRIGSRC.START_SRC and TRIGSRC.STOP_SRC to AUX_TDC_PRE. It is recommended to use the prescaler when the signal frequency to measure exceeds 1/10th of the AUX clock frequency. |
result | Result Result of last TDC conversion |
satcfg | Saturation Configuration |
stat | Status |
trigcnt | Trigger Counter Stop-counter control and status. |
trigcntcfg | Trigger Counter Configuration Stop-counter configuration. |
trigcntload | Trigger Counter Load Stop-counter load. |
trigsrc | Trigger Source Select source and polarity for TDC start and stop events. See the Technical Reference Manual for event timing requirements. |
Structs
CTL | Control |
PRECNT | Prescaler Counter |
PRECTL | Prescaler Control The prescaler can be used to count events that are faster than the AUX clock frequency. It can be used to: - count pulses on a specified event from the asynchronous event bus. - prescale a specified event from the asynchronous event bus. To use the prescaler output as an event source in TDC measurements you must set both TRIGSRC.START_SRC and TRIGSRC.STOP_SRC to AUX_TDC_PRE. It is recommended to use the prescaler when the signal frequency to measure exceeds 1/10th of the AUX clock frequency. |
RESULT | Result Result of last TDC conversion |
RegisterBlock | Register block |
SATCFG | Saturation Configuration |
STAT | Status |
TRIGCNT | Trigger Counter Stop-counter control and status. |
TRIGCNTCFG | Trigger Counter Configuration Stop-counter configuration. |
TRIGCNTLOAD | Trigger Counter Load Stop-counter load. |
TRIGSRC | Trigger Source Select source and polarity for TDC start and stop events. See the Technical Reference Manual for event timing requirements. |