[−][src]Struct cc13x2_cc26x2_pac::AUX_AIODIO1
AUX Analog Digital Input Output Controller (AUX_AIODIO) controls the general purpose input output pins of the AUX domain. These pins are referenced as AUXIO and can: - be connected to analog AUX modules, such as comparators and ADC. - be used by AUX_SCE. - connect to AUX_SPIM SCLK, MISO and MOSI signals. - connect to the asynchronous AUX event bus. Enabled digital inputs are synchronized at SCE clock rate. Note that the IO mapping in the AUX domain is different from the IO mapping in the MCU domain. This means that AUXIO[n] does not map to DIO[n]. AUXIO-DIO remapping is handled by Sensor Controller Studio.
Methods
impl AUX_AIODIO1[src]
pub fn ptr() -> *const RegisterBlock[src]
Returns a pointer to the register block
Trait Implementations
impl Deref for AUX_AIODIO1[src]
type Target = RegisterBlock
The resulting type after dereferencing.
fn deref(&self) -> &RegisterBlock[src]
impl Send for AUX_AIODIO1[src]
Auto Trait Implementations
impl !Sync for AUX_AIODIO1
Blanket Implementations
impl<T, U> TryFrom for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T> From for T[src]
impl<T, U> TryInto for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T, U> Into for T where
U: From<T>, [src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self