Module cc13x2_cc26x2_hal::cpu_tpiu::ffcr

Formatter and Flush Control When one of the two single wire output (SWO) modes is selected, ENFCONT enables the formatter to be bypassed. If the formatter is bypassed, only the ITM/DWT trace source (ATDATA2) passes through. The TPIU accepts and discards data that is presented on the ETM port (ATDATA1). This function is intended to be used when it is necessary to connect a device containing an ETM to a trace capture device that is only able to capture Serial Wire Output (SWO) data. Enabling or disabling the formatter causes momentary data corruption. Note: If the selected pin protocol register (SPPR.PROTOCOL) is set to 0x00 (TracePort mode), this register always reads 0x102, because the formatter is automatically enabled. If one of the serial wire modes is then selected, the register reverts to its previously programmed value.

Structs

ENFCONTR	Value of the field
R	Value read from the register
RESERVED0R	Value of the field
RESERVED2R	Value of the field
RESERVED9R	Value of the field
TRIGINR	Value of the field
W	Value to write to the register
_ENFCONTW	Proxy
_RESERVED0W	Proxy
_RESERVED2W	Proxy
_RESERVED9W	Proxy
_TRIGINW	Proxy